7
7.1
Overview
This chapter contains all the information necessary for commissioning the product.
During commissioning, the machine manufacturer's commissioning engineer
(OEM) configures the product for use on the specific machine tool.
The settings can be reset to the factory defaults.
Further information:
84
"Reset to factory settings", Page 268
Make sure that you have read and understood the "Basic Operation"
chapter before performing the activities described below.
Further information:
"Basic operation", Page 53
The following steps must be performed only by qualified personnel.
Further information:
"Personnel qualification", Page 25
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Commissioning | Overview