Table of Contents
Advertisement
Service and maintenance | Restore configuration
Restore configuration
16.6
Backed-up settings can be restored to the product. The current configuration of the
product is replaced in the process.
Software options that were active when the settings were backed up
must be activated before restoring the settings.
A restore can be necessary in the following cases:
During commissioning, the settings are set on a product and transferred to all
identical products
Further information:
After a reset, the settings are copied back to the product
Further information:
restoring
Safely removing a USB mass storage device
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
"Steps for commissioning", Page 87
"Reset all settings", Page 284
Tap Settings in the main menu
Open in the sequence
Service
Backup and restore configuration
Restore configuration
Tap Complete restoration
If required, connect a USB mass storage device (FAT32
format) to a USB port of the product
Navigate to the folder containing the backup file
Select the backup file
Tap Select
Confirm successful transfer with OK
The system is shut down
To restart the product with the transferred configuration data,
switch the product off and then back on
Tap File management in the main menu
Navigate to the list of storage locations
Tap Safely remove
The message The storage medium can be removed now.
appears
Disconnect the USB mass storage device
16
283
Advertisement
Table of Contents
