Table of Contents
Advertisement
Mounting | Assembly of the device
4.2.3
Mounting on Multi-Pos stand
Mount the stand with the supplied M4 x 8 ISO 14581 (black) countersunk head
screws to the VESA 100 tapped holes on the rear panel of the product
Comply with the permissible tightening torque of 2.6 Nm
Using two M5 screws, you can also optionally screw the stand to a supporting
surface from the bottom
Set the desired tilt angle within the 90° tilt range
To fix the stand: Tighten the T25 screw
Comply with the tightening torque for screw T25
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 6: Product mounted on Multi-Pos
stand
Further information:
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Recommended tightening torque: 5.0 Nm
Maximum permissible tightening torque: 15.0 Nm
"Product dimensions with Multi-Pos stand", Page 298
Figure 7: Cable routing on Multi-Pos stand
4
37
Advertisement
Table of Contents
