Table of Contents
Advertisement
10
10.7
Creating a tool
In the Manual Operation mode, you can enter the tools you want to use into the
tool table.
Requirements:
A workpiece is clamped on the machine tool
The reference mark search was successfully completed
Creating a tool
174
The setup engineer (Setup) may have already made the settings in the
tool table.
Further information:
"Creating a tool table", Page 134
Tap Tools on the status bar
The Tools dialog appears
Tap Open table
The Tool table dialog appears
Tap Add
Enter a name in the Tool type input field
Tap the Diameter input field
Enter the diameter of the tool
Tap the Length input field
Enter the length of the tool
Change the unit of measure in the selection menu, if required
The entered values are converted
Confirm the entry with RET
The defined tool is added to the tool table
To protect the entry for a tool from accidental changes or
deletion, tap the Lock symbol next to the tool's entry
The symbol changes and the entry is locked
Tap Close
The Tool table dialog is closed
Manual operation | Creating a tool
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Advertisement
Table of Contents
