Setting The Units Of Measure - HEIDENHAIN POSITIP 8013 ACTIVE Operating Instructions Manual

Manual operation | Setting the units of measure
10.4

Setting the units of measure

Before you start measuring, you can modify the default units of measure in the
quick access menu of the status bar and adapt them to your requirements.
HEIDENHAIN | POSITIP 8013 ACTIVE | Operating Instructions | 01/2018
Tap the quick access menu
Set the desired unit of measure by tapping:
For Unit for linear values: mm (Millimeters) or inch
(Inch)
For Unit for angular values:
Radian: angle in radian [rad]
Decimal degrees: angle in degrees [°] with decimal
places
Deg-Min-Sec: angle in degrees [°], minutes ['] and
seconds ["]
Tap Close
The selected units are displayed in the quick access menu
The displayed values are converted to the selected units
10
171