Tap Tools On The Status Bar The Tools Dialog Box Appears; Enter A Name In The Tool Type Input Field Confirm The Entry With Ret; Tap The Input Fields One After The Other, And Enter The Corresponding Values Change The Unit Of Measure In The Selection Menu, If Required The Entered Values Are Converted; Confirm The Entry With Ret The Defined Tool Is Added To The Tool Table - HEIDENHAIN ND 7000 Operating Instructions Manual

Information for the Operator | Manual operation
1.4

Creating tools

In the Manual Operation mode, you can enter the tools you want to use into the tool
table.
The setup engineer (Setup) may have already made the settings in the tool
table.
Further information: "Creating a tool table", Page 156
A workpiece is clamped on the machine tool
The axes have been homed
1.5

Selecting a tool

The currently selected tool is displayed on the status bar. Here you can also access
the tool table where you can select the tool you want to use. The associated tool
parameters are applied automatically.
The setup engineer (Setup) may have already made the settings in the tool
table.
Further information: "Creating a tool table", Page 156
HEIDENHAIN | ND 7000 | Operating Instructions Drilling with radial drilling machines | 08/2023
Tap Tools on the status bar
The Tools dialog box appears.
Tap Open table
The Tool table dialog box appears.
Tap Add
Enter a name in the Tool type input field
Confirm the entry with RET
Tap the input fields one after the other, and enter the
corresponding values
Change the unit of measure in the selection menu, if required
The entered values are converted.
Confirm the entry with RET
The defined tool is added to the tool table.
To protect the entry for a tool from accidental changes or
deletion, tap the Lock symbol next to the tool's entry
The icon changes and the entry is locked.
Tap Close
The Tool table dialog is closed.
Tap Tools on the status bar
The Tools dialog box appears.
Tap the tool you want to use
Tap Confirm
The associated tool parameters are applied automatically.
The selected tool is shown on the status bar.
Mount the desired tool on the machine tool
III
227