Rear Drive Shaft Installation - Polaris Sportsman XP 1000 S 2020 Service Manual

REAR DRIVE SHAFT INSTALLATION

1. Install a new spring ring on the end of the drive shaft if
not replacing the drive shaft assembly. Apply an anti-
seize compound to the splines.
2. Align splines of the drive shaft with the transmission
and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft if
necessary.
3. Rotate the bearing carrier onto the drive axle and
rotate into upper A-arm.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
4. Install the upper bearing carrier fastener.
5. Refer to Rear Bearing Carrier Installation page 8.37
to reassemble the vehicle.
FINAL DRIVE
8
8.39