Camshaft Installation / Timing - Polaris RANGER XP 900 2013 Manual

ENGINE
7. Install and finger tighten the two outer M6 bolts
evenly.
Install new cylinder head bolts.
8. Torque cylinder head
specification.
TORQUE
Cylinder Head Torque Procedure:
Torque in sequence:
Step 1: 9 ft-lbs (12 Nm)
Step 2: 26 ft-lb (35 Nm)
Step 3: Additional 180°
Step 4: M6 bolts: 7 ft-lb (10 Nm)
3.78
NOTE
bolts in sequence
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
y

CAMSHAFT INSTALLATION / TIMING

If any valve train components were replaced, refer to
"Valve Clearance Adjustment" procedure prior to
"Camshaft Installation / Timing".
1. Rotate the engine until the flywheel Top Dead Center
(TDC) mark
Crankshaft Position Sensor (CPS) mounting hole
This places the PTO cylinder at TDC for camshaft
installation.
to
DO NOT use the "V" mark located on the flywheel
opposite of the "I" mark. Only the "I" mark should be
used as a TDC reference.
2. Reference the intake and exhaust markings made
during disassembly. If installing new camshafts or if
camshafts were not marked, you can reference the
part number stamped on the end of the shafts.
Intake Camshaft - PN 1204583
Exhaust Camshaft - PN 1204584
3. Lubricate all camshaft lobes and bearing journal
surfaces with Polaris PS-4 engine oil prior to
installation.
NOTE
q
is aligned or centered in the
NOTE
© Copyright Polaris Sales Inc.
w
.