Table of Contents
Advertisement
USER'S GUIDE
4.
Select a Line Interface Type. The point-to-point interface type is most often used in the US; point-
multipoint is most often used in Japan.
5.
Select a TEI Negotiation scheme. This designates whether or not Automatic TEI Negotiation will
be used. Select Automatic TEI Negotiation (Auto) UNLESS the network contains point-to-point
NTT lines.
6.
If you select Non-Auto for the TEI Negotiation scheme, you will need to enter a TEI value. A TEI
value of 0 is normally correct for a point-to-point NTT line.
C
P
ONFIGURING
RIMARY
This section shows you how to configure PRI resources for the site template. The screen below
shows a basic PRI configuration.
1.
Select a Switch Type.
2.
If you select the NET5 switch type, select a Switch Country. The switch country associates the
switch type with the particular European country in which the site is located.
3.
If you select the Teleos Simulator switch type you will need to select its Simulated Switch Type.
4.
Select a Synchronization type. Every framed transmission line requires a clock source from
which it must derive the appropriate bit timing and channel timing relative to the start of a
frame. For most CPE gear, the clocking is derived from the received signal and the transmission
clock is thus a slave to the network. However, if the line is to provide its own clocking, it must
44
SFVRA Configuration Manager
R
(PRI) R
ATE
ESOURCES
Advertisement
Table of Contents
