Table of Contents
Advertisement
Switch
Do Not Respond
RIP Version 1 Only
RIP Version 2 Only
RIP Version 1 or
Version 2
d. v2 Auth Password: This password is only required if the site will be using IP RIP v2 with a
password required. The password is user-defined, 1-16 characters in length.
C
IPX I
ONFIGURING
NFORMATION
This section shows you how to configure IPX information for the site template. The screen below
shows a basic IPX configuration.
1.
For sites using IPX, make sure Enable is checked. When enabled, the system will process and
forward IPX data packets at the IPX network layer. When disabled, the system will process and
forward IPX data packets at the MAC or bridging layer.
2.
Select a Packet Encapsulation type. This specifies the IPX datagram encapsulation type in use.
NetWare supports four types of encapsulation: Novell ETHERNET_SNAP, Novell Ethernet
Meaning
This switch indicates responding to no IP RIP
requests at all.
This switch indicates responding only to IP RIP
requests compliant with RFC 1058.
This switch indicates responding only to IP RIP v2
requests compliant with RFC 1723.
This switch indicates responding with the same IP
RIP version format as the version of the request.
C
S
ONFIGURING
ITE
Configuring Template Options
SFVRA Configuration Manager
T
EMPLATES
51
Advertisement
Table of Contents
