Table of Contents
Advertisement
3.
Select the Source Site Name. This is the starting point of the static route. In other words, this is
the site that will be using the static route to connect with the subnet.
4.
Select the Source System ID. This is the specific system at the source site that will be using the
static route to connect with the subnet.
5.
If this static route is over a WAN UnNumbered interface:
a.
Make sure a check appears next to Use WAN UnNumbered Interface.
b. Select the Next Hop Site Name. This is the device that is the next hop gateway that provides
access to the destination subnet.
6.
If this static route is over a WAN Numbered interface:
a.
Make sure no check appears next to Use WAN UnNumbered Interface.
b. Enter a Next Hop Address. This is an IP address using dotted decimal notation for the next
hop gateway that provides access to the destination subnet.
7.
Enter the Metric value. This is the administrative distance to the destination subnet. The
distance is typically measured by the number of hop counts (number of routers) between the
source system and the destination subnet, but it is up to you to assign proper value to each
route entry. If multiple routes exist to the same destination, the route with the least metric value
will be chosen as the primary route. Care must be taken when assigning a metric value of 0,
because 0 means the destination is reachable directly and therefore no intermediate router will
be used.
8.
Select the RIP Propagation control. This controls how a static route is propagated via IP RIP. The
following table defines possible RIP propagation options.
Flag
Always Propagate
Propagate when
next hop connected
Do not Propagate
9.
Click OK. Repeat steps 2 through 8 to add any additional static routes to this subnet.
Meaning
The route information is always propagated via RIP.
Available when the next hop is over a LAN or a WAN
interface.
The route information is propagated via RIP only when
the next hop router is connected to the system.
Available when the next hop is over a WAN interface.
The static route information is not propagated over the
interface.
Available only when the next hop is over a LAN or
WAN interface.
C
IP N
ONFIGURING
ETWORK
Configuring IP Network Subnet Information
SFVRA Configuration Manager
I
NFORMATION
111
Advertisement
Table of Contents
