Table of Contents
Advertisement
USER'S GUIDE
C
V.35
ONFIGURING
OR
This section shows you how to configure V.35 and RS232 resources for the site template. The
parameters are identical for both resources. The screen below shows a basic V.35 configuration.
1.
Select a Line Type. This differentiates the network connections from local computing device
connections. The network line type is specified for lines using a dedicated, frame relay, or X.25
access.
2.
Select a Data Line Idle Character. This identifies the idle character which is transmitted by the
Cabletron system between the HDLC frames. The character choices are marks (all '1's) or HDLC
flags (hexadecimal '7E'), with marks being the default. In most situations, the default value is
acceptable, as the receiving side should be able to identify the start of a new frame after
reception of either idle character. However, there may be some receiving devices that cannot
make this determination with the default of idle marks. If communication cannot be
established with the receiving device, you may need to set the idle character to a value that the
receiving device will understand.
46
SFVRA Configuration Manager
RS232 R
ESOURCES
Advertisement
Table of Contents
