Table of Contents
Advertisement
USER'S GUIDE
C
SNMP I
ONFIGURING
This section shows you how to configure SNMP information for the site template. The screen below
shows a basic SNMP configuration.
1.
For sites using SNMP, make sure Enable is checked. All SNMP parameters will then take effect.
On the above screen, SNMP is disabled.
2.
Select whether or not the site's systems will Generate Authentication Traps. The
snmpEnableAuthenTraps object of the MIB-II SNMP group will be initialized to what you
configure (either enabled or disabled).
3.
Select whether or not the site's systems will Generate ISDN B-Channel Usage Traps. When
enabled, you can use these generated traps to monitor the system's ISDN B-channel usage.
There are two distinct ISDN B-Channel Usage Traps. The isdnUsageHigh trap is generated
when the B-channel threshold (configured below) is met or exceeded. The isdnUsageNormal
trap is generated when the number of B-channels in use drops back below the configured
threshold value.
4.
Set the ISDN B-Channel Usage Trap Threshold. This value is used to trigger the ISDN B-Channel
Usage Traps. The threshold value is a number between 1 and the total number of available B-
channels.
54
SFVRA Configuration Manager
NFORMATION
Advertisement
Table of Contents
