Table of Contents
Advertisement
USER'S GUIDE
4.
If you would like IP addresses to be dynamically assigned, check Dynamic Address Assignment.
C
IPX I
ONFIGURING
NFORMATION
1.
Click on the IPX tab to display the following IPX dialog box.
2.
Check Enable to enable IPX routing.
3.
To allow IPX dial out, check Make calls for IPX data.
4.
Check Enable IPX WAN if a site's system will be connected to a remote device that is an IPX
router. This will ensure that IPX WAN protocol will immediately succeed IPXCP negotiations.
5.
Select an IPX Routing Protocol. This is the protocol the remote device will be using to
communicate with the Cabletron system. Available protocols are:
•
None
•
RIP/SAP
•
Triggered RIP/SAP
6.
If you have selected Triggered RIP/SAP as the IPX routing protocol, you will need to select a
WAN Peer Type. Choices are:
•
Active: an active WAN peer receives and sends information at all times.
•
Passive: a passive WAN peer receives/sends information only when a connection is up.
66
SFVRA Configuration Manager
Advertisement
Table of Contents
