Table of Contents
Advertisement
USER'S GUIDE
2. Select a data source for your device from the displayed list. The screen for the data source may
vary depending on the version of ODBC driver you are using. We provide an example screen
below.
Note that your SFVRA data source will not appear on the list unless you have configured an
ODBC data source name for the source. This can be done through your device's Control Panel
(use the instructions provided in
You can also configure a data source through the above menu.
The following directions apply to the above menu. Your screen, as noted above, may appear
differently, but should generally ask for the same information.
a.
Click on New. The following screen will be displayed.
b. Select SQL Server as the Installed ODBC Driver.
c.
Click on OK.
d. Click on System DSN (so that a check mark appears next to it).
e.
Click on OK.
f.
Enter the data source name.
g. For Server, select the device on which the SQL server was installed.
154
SFVRA Configuration Manager
ODBC
Setup, substituting SFVRA information where needed).
Advertisement
Table of Contents
