Table of Contents
Advertisement
C
PPP I
ONFIGURING
NFORMATION
This section shows you how to configure PPP information for the site template. The screen below
shows a basic PPP configuration.
Note:
A thorough understanding of PPP protocol is required before you attempt to change the
PPP configuration. By changing the PPP configuration, you are changing the PPP protocol
negotiation parameters. These parameters only need to be changed when you are
interoperating with devices that do not provide a standard PPP implementation. Changing
these parameters can result in PPP option negotiation failure and the inability to
communicate with remote devices. The default parameters are adequate for most sites.
1.
Enter the Global PPP Options values.
a.
Enter the Max Terminate. This is the number of Terminate-Request packets sent without
receiving a Terminate-Ack before assuming that the peer is unable to respond.
b. Enter the Max Configure. This is the number of Configure-Request packets sent without
receiving a valid Configure-Ack, Configure-Nak, or Configure-Reject before assuming that
the peer is unable to respond.
c.
Enter the Max Failure. This is the number of Configure-Nak packets sent without sending
a Configure-Ack before assuming that configuration is not converging. Any additional
Configure-Nak packets are converted to Configure-Reject packets.
d. Enter the Restart Timer value. This times transmissions of Configure-Request and
Terminate-Request packets. Expiration of the timer causes a timeout event, and
retransmission of the corresponding Configure-Request or Terminate-Request packet.
C
S
ONFIGURING
ITE
Configuring Template Options
SFVRA Configuration Manager
T
EMPLATES
55
Advertisement
Table of Contents
