Table of Contents
Advertisement
USER'S GUIDE
7.
Select the Remote Sites that will connect to the central site. Do this by clicking on the desired site
names. As shown below, the sites you have selected will be highlighted after they are selected.
If all sites are remote sites, click on Select All. To clear the sites you have selected, click on Clear
All.
8.
To automatically configure a connection between the remote sites and the central site, make
sure there is a check next to Add connection to Central Site when Remote Site is added. This will
result in a star type configuration. It is also possible to edit the configuration so that it is not a
standard star configuration. Refer to
9.
To add more connection groups, click on OK, then click on Clear, then repeat steps 3 through 8.
It is convenient to enter BRI circuit and PRI circuit directory numbers and hunt groups before
adding connections. Refer to
instructions for configuring directory and hunt group numbers. When directory numbers and hunt
group numbers are configured for circuits before connections are configured, then connection dial
out phone numbers will automatically be set when the connection is added. Changes should not be
necessary for most of this information, with two exceptions. You may need to adjust dial-out
numbers, and, if the connection uses CLID security, you will need to enter Calling Line IDs.
Instructions for making these changes are included in
Note:
Once you configure the connection group, all new phone numbers or modifications to old
phone numbers must be done through the connection group; changes made to the circuit
information will not be reflected under the previously configured connection group
information.
86
SFVRA Configuration Manager
Modifying Star Configurations
Configuring Circuit Properties
for instructions.
and
Configuring Circuit Data Links
Modifying Connection
Information.
for
Advertisement
Table of Contents
