USER'S GUIDE
3.
Select the Destination Segment Name from the list of previously configured segments. This is the
static route's destination segment.
4.
If this static route is over a WAN UnNumbered interface:
a.
Make sure a check appears next to Use WAN UnNumbered Interface.
b. Select the Next Hop Site Name. This is the device that is the next hop gateway that provides
access to the destination segment.
5.
If this static route is over a WAN Numbered interface:
a.
Make sure no check appears next to Use WAN UnNumbered Interface.
b. Enter a Next Hop Network Number. This is the network number for the next hop gateway
that provides access to the destination segment.
c.
Enter the Next Hop Node ID.
6.
Enter the Number of Hops. (For a definition, refer to page 136).
7.
Click OK. Repeat steps 2 through 6 to add any additional static routes for this system.
142
SFVRA Configuration Manager