New Network Configuration - Cabletron Systems CyberSWITCH CSX150 User Manual

SFVRA-CFG
Application
3 Copying configuration
files to folder
Downloading files
to remote system
CSX5500
Refer to the section below that pertains to your configuration situation.
N N C
EW ETWORK ONFIGURATION
SFVRA-CFG is a valuable tool when setting up a new network. At a central location, you can use
SFVRA-CFG to configure new CyberSWITCH systems or SmartSwitch Remote Access Modules,
one at a time, then ship them to their remote sites.
The steps for configuring a new network are:
1. Access the system using a device running a terminal application. Connect one end of the
supplied null modem cable to the RS232 console port on the module or CyberSWITCH, and the
other end of the cable to the communication port on the device. On the device you must then
execute a communication package to emulate a terminal (VT100).
Downloading
1
configuration files
to new systems
2 Downloading updated
configuration files
to a remote site
ISDN
MMAC-Plus with
SmartSWITCH
Remote Access Module
U SFVRA-CFG A
SING THE
SFVRA-CFG Configuration Scenarios
Assign IP Address
using ipconfig command
WORKGROUP REMOTE ACCESS SWITCH
B-CHANNELS E1 ONLY
LAN
POWER SERVICE TX RX 10BASE-T B1 B3 B5 B7 B9 B11 B13 B15 B17 B19 B21 B23 B25 B27 B29 B31
E1 T1
B2 B4 B6 B8 B10 B12 B14 B16 D B18 B20 B22 B24 D B26 B28 B30 L1
CSX1200
(IP enabled)
MMAC PLUS
C a b l e t r o n
Systems
SFVRA Configuration Manager
PPLICATION
29