Table of Contents
Advertisement
5.
Select the Circuit Group that you want to associate with this connection group. In the above
screen, both sites use the default profile.
A
P
DJUSTING
ROTOCOL
If you have enabled IP or AppleTalk protocol for this connection, then you will need to adjust the
connection information to reflect the correct IP subnet or AppleTalk segment associated with this
connection. Both IP and AppleTalk information is located under the connection Protocols
information. To adjust this information:
1.
From the Connection Groups' main dialog box, click on the Connection Group Name that is
associated with the connection for which you want to modify the protocol information, then
click on Select (or simply double click on the Connection Group Name).
2.
From the resulting screen, click on Edit Group Connections.
3.
From the resulting [Site Name] Connections screen, click on the particular connection that you
want to make the changes to, then click Edit (or simply double click on the connection).
4.
From the resulting screen, click on the Protocols tab. You will then see the following screen:
5.
If this connection uses IP, make sure there is a check mark by Enable. Select the IP Subnet
associated with this connection from the IP screen shown above. Also, under IP Subnet select
(UnNumbered) if the connection uses an IP WAN UnNumbered interface.
I
NFORMATION
C
C
ONFIGURING
ONNECTION
Modifying Connection Information
SFVRA Configuration Manager
G
ROUPS
97
Advertisement
Table of Contents
