Table of Contents
Advertisement
As we stated earlier in this chapter, you cannot currently use SFVRA-CFG to configure IP filters. If
IP filters are a requirement for your network, there is a way you can configure IP filters by using
the system's CFGEDIT configuration utility. You must follow these instructions carefully: do not
make any other changes to your system's configuration besides the IP filter configuration. If you
make any other changes to the configuration through CFGEDIT, they will be overwritten next time
you use SFVA-CFG. The IP filter configuration file is a separate file, and it will not be overwritten.
To configure IP filters using CFGEDIT:
1.
At the system prompt, enter the following console command to start-up CFGEDIT:
cfgedit
2.
Refer to the Configuring Advanced IP Routing chapter of the Central Site CyberSWITCH
User's Guide for instructions for configuring the IP filters.
3.
Save your changes and exit CFGEDIT. You will need to restart the system for the changes to
take effect.
We must emphasize again that to be able to use SFVRA-CFG again to make configuration changes
to your system, you must not make any other to your system's changes through CFGEDIT except for the
IP filter configuration.
C
IP N
ONFIGURING
ETWORK
Configuring IP Filters
SFVRA Configuration Manager
I
NFORMATION
119
Advertisement
Table of Contents
