Electrical Connections - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual
8. VENTILATION CLEARANCE: Whether the analyzer is set up on a bench or
installed into an instrument rack, be sure to leave sufficient ventilation
clearance.
Back of the instrument
Sides of the instrument
Above and below the instrument
Various rack mount kits are available for this analyzer. See Section 5.1 of this
manual for more information.

3.1.1. Electrical Connections

1. Refer to Figure 3-2 for the location of the rear panel electrical connections.
2. Attach a strip chart recorder and/or data-logger to the appropriate contacts of
the Analog Out connecter on the rear panel of the analyzer.
The A1 and A2 channels output a signal that is proportional to the O
of the Sample Gas.
P/N 04316 Rev: B
Area
Check the voltage and frequency label on the rear panel of the
instrument (See Figure 3-2) for compatibility with the local
power before plugging the M400E into line power.
Power connection MUST have functioning ground connection.
ANALOG OUT
A1 A2
+ - +
Minimum Required
Clearance
4 in.
1 in.
1 in.
CAUTION
CAUTION
A3 A4
- + - +
Getting Started
-
concentration
3
25