Leica CV5030 Instructions For Use Manual page 96

8
Malfunctions and Troubleshooting
Problem
The cover slips
have been
deposited on the
specimen
slide incorrectly.
The cover slips
have been
deposited on the
specimen slide
at the incorrect
position.
Intact cover
slips are
conveyed into
the cover slip
catch tray.
96
Possible cause
1. The cover
slip magazine
is inserted
incorrectly.
2. The cover slips
stick to each
other.
3. The cover slip
sensor is dirty.
1. The cover slips
have been
inserted into
the coverslip
magazine
incorrectly.
2. The parameter
CSP has been
selected
incorrectly.
1. The cover slip
sensor is dirty.
2. The suction
cups are
deformed.
Remedy
1. Check how the coverslip magazine is seated; remove
any dirt or remnants of glass from in/under the
coverslip magazine.
2. Use cover slips of sufficient quality and store them in a
dry place.
3. Check the cover slip sensor for dirt; if necessary, clean
the sensor with a cloth soaked in compatible solvent.
Warning
Attention! If the actions described above do not remedy
the problem that has occurred, contact the responsible
Leica Service.
1. The cover slips have to be flush against the edge of the
front side in the coverslip magazine.
2. The parameter CSP (coverslip position = cover slip
placement position) has to be corrected. In addition, it
may be necessary to modify the parameter
position = starting point of the coverslip mountant
stroke) (→ p. 59 – 5.10 MENU A — parameter
settings).
1. Check the cover slip sensor for dirt; if necessary, clean
the sensor with a lint-free cloth soaked in compatible
solvent.
2. Replace the suction cups.
STP (stroke
Version 3.4, Revision M