Workstation Operation; Operation As St5010 - Cv5030 Workstation - Leica CV5030 Instructions For Use Manual

6

Workstation operation

6. Workstation operation
6.1 Operation as ST5010 — CV5030 workstation
Both instruments are connected to each other via a TS5015 Transfer Station.
• Specimen slide holders
transfer station by a transfer arm (→ Fig. 46-2).
• The message STAINER PROC.
2
4
Fig. 46
• Afterwards, the specimen slide holder is transfered to the Leica CV5030, placed in the loading bath and
processed.
After the coverslipping operation, the empty specimen slide holder is transferred back onto the
discharge chute of the transfer station. The display shows READY.
• If the discharge chute is already occupied with two empty specimen slide holders, an additional
FULL message is shown in the display of the Leica CV5030.
• With a third specimen slide holder, the discharge chute is completely occupied and the robotic
coverslipper emits a signal tone, accompanied by the messages
coverslipper is now in pause mode. The specimen slide holders now have to be removed, as otherwise
work cannot continue. To do so, confirm the signal tone with the RESPOND button.
74
(→ Fig. 46-3) are conveyed from the unload station
appears on the display.
1
3
(→ Fig. 46-1)
TS FULL and PAUSED. The robotic
Version 3.4, Revision M
into the
TS