Attaching The Exhaust Hose; Installing The Dispenser Group - Leica CV5030 Instructions For Use Manual

4
Instrument Setup
• Unscrew the screw
cover upwards.
• The insertion date can be written down on the adhesive label (→ Fig. 9-4).
• Insert the filter (→ Fig. 9-5), close the cover
(→ Fig. 9-2).
• Finally, close the service door and retighten the slotted screw.

4.5.2 Attaching the exhaust hose

• For installation, push the exhaust hose
(refer to the arrow in the detailed figure); the pipe is on the rear side of the service door (→ Fig. 9-1).
Note
(→ Fig. 9) detail: Assembly of the exhaust hose (→ Fig. 9-8). The filter cover (→ Fig. 9-3) and filter
(→ Fig. 9-5) have been removed to show the connecting piece (→ Fig. 9-6).
4.6

Installing the dispenser group

1. Take the dispenser group
3
6
Fig. 10
2. Insert the dispenser
(→ Fig. 11).
3. Insert the pressure hose
the compressed air output
4. To take the pressure hose back out, press the white ring
pressure hose.
5. Plug the cable
it in place using the knurled screw (→ Fig. 10-4).
6. Screw the cover
bottle into the holder (→ Fig. 12).
26
(→ Fig. 9-2) of the filter cover (→ Fig. 9-3)
(→ Fig. 9-8)
(→ Fig. 10)
2
5
1
4
(→ Fig. 11-1) into the holder
(→ Fig. 10-2)
(→ Fig. 11-5)
(→ Fig. 11-3) from the dispenser valve into the socket
(→ Fig. 10-5) onto the mountant bottle
using a No. 3 Allen key and pivot the
(→ Fig. 9-3) and secure it back in place using the screw
onto the pipe (→ Fig. 9-6)
out of the packaging.
(→ Fig. 11-4)
from the cover of the mountant bottle
up to the stop inside.
(→ Fig. 11-6)
(→ Fig. 12-1)
as far as it will go
for the prime position
(→ Fig. 10-5)
down and pull out the
(→ Fig. 11-7) and screw
and place the mountant
Version 3.4, Revision M
into