Leica CV5030 Instructions For Use Manual page 33

2
Fig. 20
1. Insert the brush
each on the left and right) fit into the notches (→ Fig. 20-4)
2. Now, attach the lid
Installation of the dispenser needle cleaner
L To install the holder for the dispenser needle cleaner, you must first remove the transport anchors
for the Pick & Place module
(→ Fig. 7).
1. For installation, use the threaded holes
2. First, fasten the mounting bracket
(→ Fig. 21-4)
parallel to the edge of the housing wall (ellipse, (→ Fig. 21)).
1
Fig. 21
3. Then, fasten the holder
and shim (→ Fig. 22-2).
Leica CV5030
1
3
(→ Fig. 20-1) into the container so that the lateral guides
(→ Fig. 20-5) and push it down until it clicks into place.
(→ p. 23 – 4.3.1 Removing or installing the transport anchors)
(→ Fig. 21-2)
using the two screws (→ Fig. 21-3). Make sure that the mounting bracket is
(→ Fig. 22-3)
4
provided.
(→ Fig. 21-1) of the transport anchor.
in the bores (→ Fig. 21-1)
3
2
on the mounting bracket using the screw
Instrument Setup
5
(→ Fig. 20-2) (2
in the housing wall
4
(→ Fig. 22-1)
4
33