Leica CV5030 Instructions For Use Manual page 77

Note
An automatic transport of the specimen slide holders is ensured only if
staining protocols as the last station.
• After the coverslipping operation, the empty specimen slide holder is transferred back onto the
discharge chute
• If the discharge chute is already occupied with two empty specimen slide holders, an additional
TS FULL message is shown on the display of the Leica CV5030.
• With a third specimen slide holder, the discharge chute is completely occupied and the robotic
coverslipper emits a signal tone, accompanied by the messages
coverslipper is now in pause mode. The specimen slide holders now have to be removed, as otherwise
work cannot continue. To do so, confirm the signal tone with the RESPOND button. All empty specimen
slide holders must be removed from the discharge chute and the drawer of the transfer station must
be closed. Then, press the START button, so that the
from the slide stainer to the robotic coverslipper is now possible once again (→ Fig. 48-1).
4
Fig. 48
Leica CV5030
(→ Fig. 48-4) of the transfer station. The display shows READY.
5 2 3 1
Workstation operation
CV was programmed in the
TS FULL and PAUSED. The robotic
READY message appears on the display. Transfer
6
77