Installing The Accessories - Leica CV5030 Instructions For Use Manual

4
Instrument Setup
3. The SERIAL
either the Leica ST 5010 (via the transfer station Leica TS 5015) or the Leica ST5020 (via the
transfer station Leica TS 5025) if both instruments are being operated together as a workstation
(→ p. 74 – 6. Workstation
use this port for servicing purposes. The below
servicing purposes by authorized Leica representatives.
2
1
Fig. 25

4.10 Installing the accessories

Cover slip catch tray
L The cover slip catch tray
» Hook the cover slip catch tray into the slide holder outfeed, inserting it towards the right as shown
(→ Fig. 26-1); always ensure that it is securely in place
Note
There are two interface ports:
The SERIAL port
intercommunication interface to either the Leica ST5010 or the Leica ST5020 via the transfer station
Leica TS5025. On the other hand it serves as service interface. For you as a customer only the first
purpose is allowed for use.
The RS 485 port
any purpose.
36
interface port (→ Fig. 25-2)
operation). Only authorized Leica representatives are allowed to
(→ Fig. 26-2)
(→ Fig. 47-3) has two functions. On the one hand this RS 232 port serves as an
(→ Fig. 47-5) serves a pure service interface. Customers are not allowed to use it for
is intended as an intercommunication interface to
RS 485 interface port is completely reserved for
3
is used to hold cover slips broken by the cover slip mount.
Version 3.4, Revision M