Leica CV5030 Instructions For Use Manual page 50

5
Operation
Empty coverslip magazine
Cover slips damaged
50
• Only press the START button to continue working after
doing so. The instrument then initializes.
• Continue as outlined in
instrument on or off).
Warning
The output magazines are moved to the output
position automatically after pressing START. All
remaining specimen slides in the output magazines
absolutely must be removed.
If the number of cover slips falls below the limit, the
message COVERSLIPS LOW
The instrument continues to operate until there are no more
cover slips in the cover slip magazine. In this case, the
messages PAUSED and
and a signal tone is emitted.
• Switch off the signal tone with RESPOND.
• Fill the cover slip magazine and then continue the
coverslipping operation by pressing START.
• The cover slip sensor between the suction cups in the
Pick & Place module automatically detects defective cover
slips.
Note
The damaged cover slips are discarded into the
cover slip catch tray.
• The coverslipping operation continues automatically if an
undamaged cover slip is picked up next.
• The coverslipping operation is interrupted if three
damaged cover slips in a row are detected and discarded.
The messages PAUSED
displayed accompanied by a signal tone.
• Confirm the signal tone with RESPOND.
• Check the cover slips in the cover slip magazine for
further damage and fill with new cover slips if necessary.
(→ p. 42 – 5.3 Switching the
appears on the display.
CS EMPTY are shown on the display
and COVERSLIP BROKEN
Version 3.4, Revision M
are