Brief Inspection Before Starting The Coverslipping Operation; Bath Insert For Histocore Spectra St - Leica CV5030 Instructions For Use Manual

5
Operation
5.4

Brief inspection before starting the coverslipping operation

L The following points have to be checked again before starting the coverslipping operation:
• The level of the loading bath
Fill the loading bath with the corresponding solvent. The level should reach up to the label field of the
specimen slide when a specimen slide holder
• When inserting the loaded specimen slide holder, ensure that the specimen slide receiving the cover
slip has the side with the specimen pointing towards the user (instrument front).
2
1
3
Fig. 32
• Push the loading drawer
loading door (→ Fig. 32-4)
• Furthermore, check and, if necessary, correct the following before starting the coverslipping operation:
a. Filling of the dispenser needle cleaner.
b. Level of the coverslip mountant bottle.
c. Sufficient filling and correct positioning of the cover slip magazine.
d. Presence of the output magazines.
e. Selection of the desired parameter set

5.4.1 Bath insert for HistoCore SPECTRA ST

Note
The Bath Insert and Clip is required to to be used with the HistoCore SPECTRA ST specimen slide
holder for 30 specimens on the Leica CV5030 Robotic Coverslipper.
44
(→ Fig. 32-1) must be checked before starting the coverslipping process.
(→ Fig. 32-2)
4
(→ Fig. 32-3) with the loading bath back into the instrument; close the
afterwards.
(→ p. 59 – 5.9 Setting parameter
is inserted.
sets).
Version 3.4, Revision M