Switching The Instrument On Or Off - Leica CV5030 Instructions For Use Manual

5
Operation
RELEASE COVER SLIP
RELEASE SLIDE
PRIME
VENT MOUNTANT
EXIT
5.3

Switching the instrument on or off

LED
Note
The digits on the display show the selected coverslipping program
sets).
42
RELEASE COVER SLIP ventilates the Pick & Place module's suction cups.
The cover slip is released.
The function is disabled while the BUSY LED is illuminated in green.
Pressing RELEASE SLIDE opens the gripper jaws as long as the button is
held down.
The function is disabled while the BUSY LED is illuminated in green.
Pressing the PRIME key opens the dispensing valve as long as the key is
pressed.
The function is disabled while the BUSY LED is illuminated in green.
VENT MOUNTANT generates a vacuum in the coverslip mountant bottle,
thereby assisting the coverslip mountant with degassing.
This function is disabled if the BUSY LED is illuminated in green.
This button is used to exit the configuration menu.
Move the power switch on the front side of the instrument to
the ON = I or OFF = 0 position.
This is followed by a beep.
The instrument initializes after being switched on. The
installed software version is shown in the display.
The READY LED is illuminated in red.
CHECK BATH
bath after initialization.
To do so, open the loading door and pull out the loading
drawer. This is the last chance to remove the cover from the
bath.
is the prompt for the user to insert the loading
(→ p. 59 – 5.9 Setting parameter
Version 3.4, Revision M