Display Indicators And Instructions - Leica CV5030 Instructions For Use Manual

Fig. 36
5.7

Display indicators and instructions

Note
The display of the Leica CV5030 is used to display status and error messages that provide information
about the current status of the instrument. Status messages always appear in the bottom line of the
display. The top line displays the operating status of the instrument. The following table compiles all
status messages. In addition, it indicates to the user which action to carry out. All error messages
displayed on the control unit of the device are listed in
Display
Leica CV5030
• Confirm the signal tone with RESPOND.
• Remove the cover slip magazine carefully.
Warning
Put the dispenser into park position to prevent damage
to the specimen and / or dispenser needle.
• Carefully pull the Pick & Place module forwards
1
(→ Fig. 36-1)
coverslipped from the specimen slide outfeed.
• Carefully remove the lost cover slip from the instrument.
Note
Coverslip the removed specimen slide manually
or, if the coverslip mountant has already begun to
dry, immerse the specimen slide in a compatible
solvent, remove the coverslip mountant and re-
insert the specimen slide into the instrument for
coverslipping.
• Check the suction cups of the Pick & Place module for
adhesive residue and, if necessary, clean them using a lint-
free cloth moistened with compatible solvent or replace
them with new ones
replacing the suction
• Re-insert the cover slip magazine.
• Move the dispenser back into working position.
• Press the START key to resume the coverslipping
operation.
(→ p. 91 – 8.1 Error
Explanation
Appears after switching on
the instrument. Indicates
that the instrument is being
initialized.
and remove the specimen slide to be
(→ p. 85 – 7.5.9 Cleaning and
cups).
codes).
Action
Do not press any buttons; wait until
the device is fully initialized and the
next message appears.
5
Operation
53