Blackmagicdesign ATEM mini Installation And Operation Manual page 168

Hide thumbs Also See for ATEM mini:

Table of Contents

Available languages

CAMERA CONTROL

You can also disable the banks by holding down the bank soft button until the 'bank off' setting

appears on the LCD.

Turning the banks off lets you change the CCUs to other cameras when needed, with a defined

set of cameras ready on each bank you can access at any time. To enable banks, simply press

the bank button again.

The bank setting lets you assign 2 banks of cameras to the four CCUs and then

instantly swap between them by pressing the 'bank' soft button

you want to have constant control over camera 1, even after switching to another bank

of cameras. All you need to do is make sure one CCU in each bank always has camera

Now when switching your live production, you can press the 'bank' soft button to swap

between banks A and B, which lets you instantly access camera control for cameras

that have been assigned to dedicated CCUs. This is a faster and more organized way of

controlling cameras compared to swapping between multiple cameras on each CCU

during production.

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

Any camera can be selected on each CCU in both banks. For example, imagine

Press the bank soft button

to cycle between camera

banks A and B, or hold the

button down to disable or

enable camera banks

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

CAMERA CONTROL

Using ATEM Camera Control Panel

Chapters

Table of Contents