Blackmagicdesign ATEM mini Installation And Operation Manual page 128

Now you should see video appearing on the HDMI Television.
Network Status Indicators
There are 4 lights on the ATEM Streaming Bridge that provide information on the state of the
network connection. The 2 LEDs on the Ethernet connector will show the state of the
connection itself. The right orange LED indicates the network is up and connected ok.
The left green LED will show network activity.
The INTERNET OK indicator will illuminate when the ATEM Streaming Bridge can see the Internet.
It indicates your Internet connection is ok and the port forwarding has been setup correctly.
The STREAM OK indicator shows the ATEM Streaming Bridge is receiving streaming data from
an ATEM Mini Pro or Extreme switcher. If you don't see images out of the video connections but
this LED is illuminated then you might have a problem with your video connections. Try
connecting a monitor direct to the SDI or HDMI outputs of your ATEM Streaming Bridge.
ATEM Streaming Bridge does not appear
If the ATEM Streaming Bridge does not appear in the list, then it's important to confirm both the
ATEM Streaming Bridge and the ATEM Mini Pro or Extreme switcher are on the same
Ethernet network.
If the ATEM Streaming Bridge still does not appear, then it could be an issue with the network
settings in the ATEM Streaming Bridge itself. This can happen if the ATEM Streaming Bridge has
been used by someone before you and they could have changed its network settings.
As new from the factory the ATEM Streaming Bridge is set to DHCP so it should connect to your
network without any settings changes required, but if it's been changed, then you will need to
check its network settings. You can change the ATEM Streaming Bridge settings using the
ATEM Setup software.
Connecting ATEM Setup software
The ATEM Setup software is found in the Blackmagic ATEM Switchers folder. It's the same
software you can use to set up your ATEM switchers and it also handles updating software in
your ATEM switchers as well as the ATEM Streaming Bridge.
Simply plug your ATEM Streaming Bridge USB-C connection to your computer and then run the
ATEM Setup software. You should see the ATEM Streaming Bridge as one of the devices you
can connect to in the ATEM Setup. Click the ATEM Streaming Bridge icon to open the settings.
Creating Video Links with ATEM Streaming Bridge 128