Setting Audio Input And Output Behavior - Blackmagicdesign ATEM mini Installation And Operation Manual

Hide thumbs Also See for ATEM mini:

Table of Contents

Available languages

Supported Video Input Standards

Setting Audio Input and Output Behavior

The 'audio' tab lets you control the nature of the audio follow video feature plus set the mic

inputs to mic or line level audio. Microphones typically have weaker signals compared to line

outputs from other audio devices. This means when mic is selected, the input is boosted

slightly to compensate. This also means that if mic is accidentally selected when a line level

input is plugged in, the audio will sound unusually loud. If the audio sounds much louder than it

should be, check that line is selected instead of mic.

Audio Follow Video Behavior

You can change the nature of the audio follow video feature for when switching sources.

For example, select 'hard cut audio when switching' to allow the audio from an input to switch

immediately to another. If you want to the audio to smoothly transition over a brief period of

time, select 'add a transition to audio when switching'.

Split a mono input signal into two separate mono channels. This is helpful for mixing a mono

input into both channels on the stereo master output. You can also add a stereo simulation

effect using the advanced Fairlight controls on the audio page.

Click on the desired input checkbox to split the channels for that input.

Changing Switcher Settings

Table of Contents