Creating Video Links With Atem Streaming Bridge; Direct Connection - Blackmagicdesign ATEM mini Installation And Operation Manual

Invert Key
Mask
Creating Video Links with
ATEM Streaming Bridge
The ATEM Streaming Bridge allows you to decode the streaming video from any ATEM Mini Pro
or Extreme and convert it back to SDI or HDMI video. It allows you to send video over your local
network, or to anywhere in the world via the internet.
You can connect ATEM Streaming Bridge in 3 different ways. One is to connect it direct to your
switcher using a simple Ethernet cable, or you can connect it via your local network, or you can
use it anywhere in the world using the Internet.

Direct Connection

The simplest way to get ATEM Streaming Bridge operating is to plug it into an ATEM Mini Pro or
Extreme switcher with a simple Ethernet cable. The switcher will see it and automatically send
video to it when you press the on air button.
Setting up a direct connection
1 Plug power into ATEM Streaming Bridge
2 Connect an Ethernet cable to the ATEM Streaming Bridge.
3 Connect a television to the HDMI on ATEM Streaming Bridge.
4 Connect the other end of the Ethernet cable to the switcher.
5 Press the On Air button on the switcher.
Now you should see video appear on the HDMI television connected to
ATEM Streaming Bridge.
Inverts the key signal.
Allows you to mask out sections of the key. For example, if you need to
select only a specific section of a graphic, you can use the mask setting to
select only the area of the graphic you want to use. To return the mask to
the default settings, select 'reset mask' and press the set button.

Creating Video Links with ATEM Streaming Bridge

126