Blackmagicdesign ATEM mini Installation And Operation Manual page 122

Background
A full screen image.
Fill
Another full screen that has been scaled, rotated or has added borders and will be overlaid on
top of the background.
Key/Cut
In the case of a DVE key, the key/cut signal is generated by the switcher's internal
DVE processor.
To set up a DVE key on upstream keyer 2 on ATEM Mini Extreme:
1 Select the DVE2 button from the select bus.
2 Select the fill source from the select bus.
3 To adjust the key parameters to refine the key, select upstream keyer 2 in ATEM
Software Control and select the DVE tab.
To set up a DVE key on the upstream keyer in ATEM Software Control:
1 Expand the upstream key palette and select the DVE tab.
2 Select the fill source.
3 Adjust the key parameters to refine the key. For a description of DVE key parameters,
refer to the information below.
Adjusting the x/y position of the DVE
You can independently adjust the x and y positions of the DVE using the position X and Y
settings, or you can tie X and Y parameters together so adjusting one will automatically adjust
the other. To achieve this, simply enable the 'tie X and Y' setting.
This also applies to the size parameters.
DVE parameters
Size X
Size Y
Reset DVE
Adding DVE Borders
DVE border parameters
The upstream key LCD menu is used to adjust the border parameters for the DVE and picture
in picture.
Border
Color
Adjusts the horizontal size of the DVE.
Adjusts the vertical size of the DVE.
Resets the DVE to screen. Useful if you lose track of the DVE
during adjustment.
Enables or disables the border.
This item appears grayed out because it is not a setting, but rather
an indicator to show you the selected border color. You can use this
indicator to quickly verify the color of the DVE border.
Keying using ATEM Mini 122