Changing Atem Mini Network Settings - Blackmagicdesign ATEM mini Installation And Operation Manual

ATEM External Hardware Panel IP Settings
IP Address - 192.168.26.40
Subnet Mask - 255.255.255.0
Gateway - 192.168.26.250
If there are other devices on the network that have the same identifying number in their
IP address, there will be a conflict and the units won't connect. If you encounter a conflict,
simply change the identifying number in the unit's IP address. Refer to the next sections for
information on how to change network settings.
NOTE If ATEM 1 M/E Advanced Panel is not connecting to your ATEM Mini and
displays a message saying it is looking for the switcher, you will need to tell the panel
where your switcher is on the network. This is simply typing your ATEM Mini's
IP address into the panel's switcher IP settings. Refer to the next sections for
information on how to set the switcher IP location on ATEM 1 M/E Advanced Panel.

Changing ATEM Mini Network Settings

ATEM Mini's network settings are changed using Blackmagic ATEM Setup via USB.
Please follow the steps below:
Change network settings using the
'configure' tab in Blackmagic ATEM Setup.
To change the network settings via Blackmagic ATEM Setup:
1 Connect ATEM Mini via USB to the computer running the setup utility software.
2 Launch Blackmagic ATEM Setup and select your ATEM Mini.
3 ATEM Mini's current IP address, subnet mask and gateway settings will be displayed in
'configure' window. If you only want to check the IP address and not change it, you can
simply quit the setup utility by clicking 'cancel'.
4 To change the IP address or any other settings, edit the numbers and then click 'save'.
Connecting to a Network 105