Setting The Hdmi Output Using The Video Out Buttons - Blackmagicdesign ATEM mini Installation And Operation Manual

Disk Status Indicator
The disk status LED indicator lets you know the status of the recording media. For example, the
indicator illuminates green if the current drive is formatted and ready to record and red while
recording.
Indicators include:
Green
Red
The record button will also indicate the performance of the drive. When the record button is
slowly flashing red, this indicates there is low disk space. When the record button flashes red
rapidly, the disk performance is poor causing skipped frames.
NOTE To record to an external drive, you first need to format the disk.
Refer to the 'preparing media for recording' section for more information.

Setting the HDMI Output using the Video Out Buttons

The video out buttons on the right side of the switcher are used to switch sources to the HDMI
output on ATEM Mini Pro and HDMI out 1 on ATEM Mini Extreme. The default output source for
ATEM Mini Pro is the multiview and you can read more about this powerful feature later in this
section. ATEM Mini Extreme's default output is program for output 1 and multiview for output 2.
Press the video out buttons to switch a source to the HDMI output
To change the HDMI output source, press any of the video out buttons. For example you can
select the HDMI inputs for isolated camera recordings, or select the program output or
multiview. Compared to ATEM Mini, having the buttons built into ATEM Mini Pro and Extreme
means you can change the HDMI output directly from the unit itself! In addition to the 8 HDMI
inputs, program and multiview, ATEM Mini Extreme lets you select a clean feed or the
preview output.
NOTE If you want to switch camera 1 direct or preview to the HDMI output, these
sources are available from the 'output' menu in ATEM Software Control.
Formatted disk is detected and ready to record.
Disk is recording.
Additional Features on ATEM Mini Pro and ATEM Mini Extreme 21