NEC Aspila Topaz Programming Manual page 96

Program 14: Trunk Basic Setup
14-02: Analogue Trunk Data Setup
Input Data(Cont'd)
Prog. No.
14-02-09 Busy Tone Detection
14-02-10
Caller-ID
Enable or Disable a trunk's ability to receive
Caller ID information
14-02-11
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the system's
ability to skip over a trunk if dial tone is not
detected. This option pertains to calls placed using
Loop Keys, Speed Dial, ARS, Last Number Redial
or Save Number dialed. It does not pertain to line
key or Direct Trunk Access calls.
14-02-12
Detect Network Disconnect Signal
14-02-13
Trunk-to-Trunk Limitation
14-02-14
Loop Start/Ground Start
14-02-15 -Not Used-
14-02-16 Caller-ID Type for Analogue Trunk
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 14-02(Analogue Trunk Data Setup):
1. Enter the programming mode.
2. Enter 14 02
14-02-01 Trunk1
DP/DTMF 1
3. Enter the number of the item you want to program.
14-02-xx Trunkxx
xxxxx
4. Select the Trunk port number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series's programming section.
Programming Manual
Item
88
COPY
Input data Default
0 : Disable
1 : Enable
0 : Disable
1 : Enable
0 : Disable
1 : Enable
0 : Disable
1 : Enable
0 : Disable
1 : Enable
0 : Loop Start
1 : Ground Start
-
0 : FSK
1 : DTMF
IN
SA
SB
Related
Program
0
0
0
0
0
0
- -
0