NEC Aspila Topaz Programming Manual page 30

Program 10: System Configuration Setup
10-08: Pre-ringing Setup
Description
Use Program 10-08 : Pre-Ringing Setup to enable or disable pre-ringing for trunk calls. This sets how a trunk
initially rings a telephone. With pre-ringing, a burst of ringing occurs as soon as the trunk's LED flashes. The call
then continues ringing with the normal ring cadence cycle. Without pre-ringing, the call starts ringing only when the
normal ring cadence cycle occurs. This may cause a ring delay, depending on when call detection occurs in
reference to the ring cycle.
Input Data
Conditions
None
Feature Cross Reference
Central Office Calls, Answering
Telephone Programming Instructions
To enter data for Program 10-08 (Pre-Ringing Setup):
1. Enter the programming mode.
2. Enter 10 08
10-08-01
Pre-ringing
3. Enter the number of the item you want to program.
10-08-xx
xxxxx
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series's programming section.
Programming Manual
Input Data
0 : disable
1 : enable
Default
0
22
IN
SA
SB
COPY