NEC Aspila Topaz Programming Manual page 136

Intelligent hybrid system
Hide thumbs Also See for Aspila Topaz:
Table of Contents

Advertisement

Program 20: System Option Setup
20-02: System Options for Key telephones
Input Data(Cont'd)
Prog. No.
20-02-09
Disconnect Supervision
Use this option to enable or disable
disconnect supervision for the system
trunks.
20-02-10
Time Before Shifting to Power-
Saving
Mode
(PRG15-02-18 should be set to "1:
Power Saving Mode".)
20-02-11
Default Setting of Microphone of Key
Telephone
20-02-12
Forced Intercom Ringing
Use this option to enable or disable
Forced Intercom Ringing. If enabled,
incoming Intercom calls normally
ring.
If disabled, Intercom calls
voice-announce.
20-02-13
-Not Used-
20-02-14
Headset Ringing Cancel Timer
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 20-02(System Options for Key Telephones):
1. Enter the programming mode.
2. Enter 20 02
20-02-01  
TRK Loop Key 0
3. Enter the number of the item you want to program.
20-02-xx
xxxxx
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series's programming section.
Programming Manual
Item
0 : Disable
1 : Enable
0 : Power-Saving Mode Off
1 : 1 minute (Min.)
2 : 2 minutes
3 : 4 minutes
4 : 8 minutes
5 : 16 minutes
6 : 32 minutes
7 : 64 minutes
0 : Off
1 : On
0 : Disable (Voice)
1 : Enable(Ring)
-
0 - 64800(sec.)
128
Input Data
IN
SA
SB
Default
0
0
1
0
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents