NEC Aspila Topaz Programming Manual page 385

IN
SA
SB
Description
Use Program 92-01 : Copy Program to copy the data for one program to another keyset, port, group, etc. Refer to
the following charts to see which programs which can be copied.
Input Data
Program Number
Prog.No.
Source Number
92-01-01 Enter the extension, trunk, group, etc.. from
which the data will be copied.
Destination Number (From)
Enter the first extension, trunk, group, etc.
92-01-02
number to which the information is to be
copied.
Destination Number (To)
Enter the last extension, trunk, group, etc.
number to which the information is to be
92-01-03 copied. If the information is only be copied to
one extension, trunk, group, etc., enter the
information entered in the Destination Number
(From) entry.
Note) Copy Program is applicable only for the following programs.
1. Trunk Port Base
Prog.No.
Trunk Basic Data Setup
14-01
14-02 Analogue Trunk Data Setup
14-04 Behind PBX Setup
14-08 Music on Hold Source for Trunks
14-09 Conversation Recording Destination for Trunk
21-03 Trunk Group Routing for Trunks
21-12 ISDN Calling Party Number Setup for Trunk
22-02 Incoming Service Type Setup
22-03 Trunk Ring Tone Setup
22-05 IRG Assignment for Normal Ring Trunk
Second IRG Setup for unanswered DIL / IRG
22-08
Incoming Ring Tone Audible on External
31-05
Speaker
Program92: Copy Program
Item
Program Name
377
92-01: Copy Command
xx-xx
Input Data
• In case of Trunk Base ....
Trunk Port Number 1-51
• In case of Trunk Group Base....
Trunk Group Number 1-25
• In case of Extension Base....
Extension Number (Up to 4 digits)
• In case of Department Group Base....
Department Group Number 1-32
• In case of DSS....
DSS Console Number 1-9
Note
Copy all data except Trunk Name (14-01-01)
Programming Manual