NEC Aspila Topaz Programming Manual page 164

Program 20: System Option Setup
20-18: Service Tone Timers
Description
Use Program 20-18 : Service Tone Timer to set the values for the system service tone timers.
Refer to the following chart for a description of each option, its range and default setting.
Input Data
Prog. No. Item
20-18-01
Extension Dial
Tone sending
Timer
20-18-02 Busy Tone sending
Timer
20-18-03
Congestion Tone
sending Timer
20-18-04 Warning Tone
sending Timer
20-18-05 KTS Confirmation
Tone sending Timer
20-18-06
Interval of Call
Waiting Tone
20-18-07 Intrusion Tone
20-18-08 Conference tone
Interval
20-18-09
Warning Beep Tone
Signaling Interval
Conditions
None
Feature Cross Reference
Distinctive Ringing, Tones, and Flash Patterns
Programming Manual
Input data Default
0 - 64800(sec.) 30
0 - 64800(sec.) 15
0-64800(sec.) 10
0-64800(sec.) 10
0-64800(sec.) 10
0-64800(sec.) 10
0-64800(sec.) 0
0-64800(sec.) 0
0-64800(sec.) 60
156
Description
After getting Intercom dial tone, a
KTS user has this interval to dial
the first digit of the Intercom call.
A Busy Tone when system
resources run short. (such as
DTMF receiver resources)
This option sets the interval
between Call Waiting tones.
This timer also sets the interval
between Off Hook Signaling
alerts.
After a call is interrupted (such as
Barge In, Voice Mail
Conversation Recording, Voice
Over, etc), the system repeats the
Intrusion Tone after this interval.
Normally, you should enter 0 to
disable this interval.
IN
SA
SB
Related
Program
14-01-18