Swinging The Jib; Function Speed Control; Machine Safety System Override (Msso); (Ce Only) - JLG 1200SJP Operation And Safety Manual

To extend or retract the main boom, use the Telescope Control
Switch to select In or Out movement.

Swinging the Jib

NOTE:
For 1000 lb (454 kg for ANSI markets and 450 kg for CE and Aus-
tralia markets) mode operation, the jib must be centered and the
Jib Swing function is not operable. If the jib is out of the centered
position when in this mode, the jib swing function will allow the
operator to center the jib again.
To swing the jib, use the Jib Swing control to select Right or Left
direction.
4.9

FUNCTION SPEED CONTROL

This control affects the speed of all boom functions and Platform
Rotate. When in the CCW maximum position, Drive is placed in
creep speed.

4.10 MACHINE SAFETY SYSTEM OVERRIDE (MSSO)

(CE ONLY)

The Machine Safety System Override (MSSO) is
used to override function controls for Emergency
Platform Retrieval only. Refer to Section 5.5,
MACHINE SAFETY SYSTEM OVERRIDE (MSSO) (CE
ONLY) for operating procedures.
31215054
SECTION 4 - MACHINE OPERATION

4.11 SKYGUARD OPERATION

SkyGuard provides enhanced control panel protection. When the
SkyGuard sensor is activated, functions in use at the time of actu-
ation will reverse or cutout. The SkyGuard Function Table pro-
vides more details on these functions.
During activation, the horn will sound and, if equipped with a
SkyGuard beacon, the beacon will illuminate until sensor and
footswitch are disengaged.
If the SkyGuard sensor remains activated after function reversal
or cutout, depress and hold the SkyGuard Override Switch to
allow normal functions until the sensor is disengaged.
Consult the following illustrations to determine which type of
SkyGuard the machine has and how it is activated. Regardless of
type, SkyGuard function according to the SkyGuard Function
Table does not change.
4-15