Method For Checking After Finishing Work; Lock - Komatsu WA600-8 Operation & Maintenance Manual

MACHINE OPERATIONS AND CONTROLS
9.
Check that the work equipment lock pilot lamp is lit on ma-
chine monitor (5).
10. Set steering lock lever (9) to LOCK position (L).

METHOD FOR CHECKING AFTER FINISHING WORK

CHECKS BEFORE STOPPING ENGINE
On the machine monitor, check the engine coolant temperature, hydraulic oil temperature, torque converter oil
temperature, remaining fuel level, and remaining DEF level.
If the engine has overheated, do not stop the engine suddenly. Run it at a medium speed to cool it gradually
before stopping.
CHECKS AFTER STOPPING ENGINE
1.
Perform walk-around check for oil or coolant leakage and for abnormality in work equipment, exterior parts,
and undercarriage.
If oil or coolant leakage or any abnormality is detected, repair it.
2.
Check DEF tank, pump, injector, hose, and joint for leakage.
If any abnormality is found, ask your Komatsu distributor for repair.
3.
Fill the fuel tank.
4.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
5.
Remove any mud affixed to the undercarriage.

LOCK

Position to be locked
Always lock the following places.
3-246
OPERATION