Method For Checking After Finishing Work; Lock - Komatsu WA200-8 Operation & Maintenance Manual

MACHINE OPERATIONS AND CONTROLS
6.
Press the work equipment lock switch (7) and lock the
work equipment (the pilot lamp in the switch is lit).

METHOD FOR CHECKING AFTER FINISHING WORK

CHECKS BEFORE STOPPING ENGINE
Check the engine coolant temperature, engine oil pressure, HST oil temperature, remaining fuel level, and re-
maining DEF level on the machine monitor.
If the engine has overheated, do not stop the engine abruptly. Run it at a medium speed to cool it down gradual-
ly before stopping.
CHECKS AFTER STOPPING ENGINE
1.
Perform walk-around check for oil or coolant leakage and for abnormality in work equipment, exterior parts,
and undercarriage.
If oil or coolant leakage or any abnormality is detected, repair it.
2.
Check DEF tank, pump, injector, hose, and joint for leakage.
If any abnormality is found, ask your Komatsu distributor for repair.
3.
Fill the fuel tank.
4.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
5.
Remove any mud affixed to the undercarriage.

LOCK

Position to be locked
Always lock the following places.
(1) Fuel tank filler cap
(2) Rear grille
(3) Engine side cover (2 places)
(4) DEF inspection cover
(5) Transfer case filler cap
(6) Cab door
(7) Air conditioner fresh air filter cover
The starting switch key is a common key for (1) to (7).
3-188
OPERATION