Table of Contents
Advertisement
OPERATION
The bucket control lever is used to operate the bucket.
(a) "TILT" position
If the bucket control lever is pulled further from "TILT" position
(a), it stops at "detent" position (d).
It stops at the set position of the remote bucket positioner and
the bucket control lever returns to "HOLD" position (b) at the
same time.
(b) "HOLD" position
The bucket remains in the position where it was stopped.
(c) "DUMP" position
REMARK
When the engine is stopped or the work equipment is locked, the bucket control lever does not stop at "detent"
position (d).
When the bucket is tilt side than level, the bucket control lever does not stop at "detent" position (d).
BOOM CONTROL LEVER
NOTICE
•
Even if the engine is stopped, if the starting switch is in ON position and the work equipment lock
pilot lamp on the machine monitor is not lit, the work equipment lock is released and the work
equipment can move.
•
Do not use "FLOAT" position when lowering the bucket.
Use "FLOAT" position for leveling work.
The boom control lever is used to control the boom.
(a) "RAISE" position
•
When the RAISE remote boom positioner is set, if the
boom control lever is pulled further from "RAISE" position
(a), the boom control lever stops at "detent" position (e),
the boom stops at set position of the RAISE remote boom
positioner, and the boom control lever returns to "HOLD"
position (b) at the same time.
•
When the RAISE remote boom positioner is not set, if the
boom control lever is pulled further from "RAISE" position
(a), the boom control lever stops at "detent" position (e),
the boom stops at the highest position, and the boom control lever returns to "HOLD" position (b) at the
same time.
(b) "HOLD" position
The boom remains in the position where it was stopped.
(c) "LOWER" position
(d) "FLOAT" position
The boom moves freely under external force.
•
When the LOWER remote boom positioner is set, if the boom control lever is set to "FLOAT" position (d),
the boom stops at set position of the LOWER remote boom positioner, and the boom control lever returns
to "HOLD" position (b) at the same time.
•
When the LOWER remote boom positioner is not set, if the boom control lever is set to "FLOAT" position
(d), the boom control lever stays at "FLOAT" position (d).
REMARK
When the engine is stopped or the work equipment is locked, the boom control lever does not stop at "detent"
position (e).
EXPLANATION OF COMPONENTS
3-127
Advertisement
Chapters
Table of Contents
