Driven Pulley Installation; Eccentric Disassembled; Eccentric Assembled - Arctic Cat Panther 1974 Manual

DRIVEN PULLEY ASSEMBLY
3.
Slide moveable sheave onto stationary sheave
hub, Fig. V-50.
Fig. V ·50
4. Install woodruff key in keyway . Seat key in
keyway, using a rubber mallet.
5. Slide spring on stationary sheave hub, Fig.
V-51, then hook spring end against casting
knurl.
6. Place cam bracket on spring, Fig. V-51, at a
point where cam bracket keyway and
woodruff key are somewhat aligned.
Fig. V -51
7. Push cam bracket onto hub, making sure that
woodruff key slides into cam bracket keyway .
Continue to push cam bracket down until tips
are just above the sliding shoes. A rubber
mallet may be used to drive cam bracket
down.
8. Rotate moveable sheave counterclockwise
until slight spring resistance is felt, then rotate
moveable sheave an additional 1/3 turn.
9. Maintaining spring preload, push cam bracket
down and lock it under the woodruff key,
Fig. V-52.
10. Install snap ring in groove of stationary sheave
hub, Fig. V -52, using a snap ring pliers.
11. Rotate cam bracket until keyway and wood-
ruff.;key alignment is ga,ined, then allow cam
bracKet to release upward against the snap
ring, Fig. V-52.
Fig. V -52
DRIVEN PULLEY INSTALLATION
Install Driven Pulley - Eccentric Disassembled
II
Note: Use this set of instructions ONL V if ec-
centric bearing and shaft WAS disassembled.
If eccentric bearing and shaft WAS NOT dis-
assembled, use next set of instructions (see Install
Driven Pulley - Eccentric Assembled, page V-39).
V-34
Equipment Necessary: Press or Vise, Flat End
Punch, Hammer, 3/32-1 nch Allen Wrench and
Arctic Chain Lube
1. Install greased bearing in eccentric housing,
Fig. V-53, using a press or vise. Bearings are
to be pressed into eccentric housing until
they bottom out on the bearing "stop".
J