Arctic Cat Panther 1974 Manual page 153

c
(
c
DRIVEN PULLEY INSTALLATION
11. SI ide eccentric shaft and sprocket in or out
until alignment is correct, then drive lock
collar forward, Fig. V-61, which will lock
adjustment in place. A 5/16 x 1/8-inch flat
end punch and hammer is to be used to drive
the lock collar. Recheck alignment and adjust
if necessary.
II
Note: Lock collar is locked tightly when
bearing begins to turn with the collar.
Fig. V-61
12. Tighten lock collar set screw, using a 1/8-inch
Allen wrench, Fig. V -62.
Fig. V-62
13. Push against capscrew
wlgrease
fitting until
cha in tightens. Chain is to have approximately
1/4-inch deflection at midspan when squeezed
together using thumb and forefinger, Fig.
V-63.
Fig. V -63
V-J7